Insinkerator F-201R Bedienungsanleitung PDF herunterladen (Seite 5)

Property Damage: Join remaining tube

to cold water supply only.

■■

Turn on the cold water supply.

■■

Run water through your unit for

at least 3 minutes to flush lines and filter.

■■

Check all connections to ensure they are

tight

and that there are no leaks.

Brass Nut

Ferrule

Brass Insert

■■

At the end of the white 3/8" tube from the

filter, slide the supplied brass nut and

ferrule over the tube and then push in the

brass tube insert.

■■

If not already equipped, install a

compression, T-fitting or saddle valve

onto the cold water supply line.

■■

Insert the white 3/8" tube into the 3/8"

compression fitting and tighten.

FINAL WATER CONNECTION

FILL TANK & THEN CONNECT POWER

If leaks present themselves, turn off water

supply, tighten fittings and repeat step 3.

F-201R Cartridge (included with this system) Chemical & Mechanical Reduction Filter Specifications: This

cartridge provides mechanical and chemical reduction of dirt/rust, taste/odor, chlorine and particulates.

Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under

standard laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or

of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be

installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty

card for warranty. For service and p

arts, contact your local dealer or InSinkErator® directly at 1-800-558-5700.

Application guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or

private well water supply, water pressure of 30-125 psi, water temperature of 33˚F–100˚F. Except as noted, all

testing performed at pH = 7.5 ± 0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp: 20˚±3˚C.

Contact an authorized InSinkErator service agent for repairs or replacement components.

Pressure: 30-125 psi

Temperature: 33

F - 100

Flow Rate: 0.75 gpm

Capacity: 500 gallons

System Tested and Certified by NSF International

against NSF/ANSI Standard 42 for the reduction of

Chlorine taste and odor and Nominal Particulate Class I.

FINAL WATER CONNECTION

TURN ON WATER & CONNECT POWER

1 2 3 4 5 6 7 8 9 10 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Insinkerator F-201R Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserausrüstung Insinkerator F-201R